gb填料是干什么用的
GB(SR)柔性填料,是專門為混凝土面板，堆石壩周邊縫和伸縮止水而開發生產的新型止水材料,它以特種橡膠為原料,具有獨特性.高塑性、耐熱性、耐寒性、耐老化性，還具有操作簡便，無毒無味，耐水、粘附性能好等特點。GB柔性填料SR柔性填料
GB (SR) is designed for flexible filling concrete dam surrounding joints and expansion and the development of new waterproof sealing material production, with special rubber as raw material, has unique characteristics. High plasticity, heat resistance, cold resistance, aging resistance, but also has the advantages of simple operation, non-toxic and tasbess, water resistance, adhesion characteristics good perbance. GB flexible packing SR flexible packing
幾年來，我公司生產的GB（SR）柔性填料，先后在十幾項水得、電力工程以及工業、民用建筑工程上應用，均取得了較好的防滲止水效果。GB柔性填料SR柔性填料YL柔性填料
In recent years, GB (SR) flexible packing produced by our company has been applied in more than ten water power projects, power engineering and industrial and civil engineering projects, and achieved better anti-seepage and sealing effect. GB flexible packing SR flexible packing YL flexible packing
gb填料是干什么用的
GB(SR)柔性填料應用范圍：GB柔性填料SR柔性填料YL柔性填料
GB (SR) flexible filler application range: GB flexible packing SR flexible packing YL flexible filler
1.各種大中型水電工程大壩的伸縮縫及邊縫的密封。
1. the expansion joint and side joint seal of various large and medium hydropower projects.
2.大型屋面板，伸縮縫，女兒墻與屋面接縫的密封。
2. large roof panels, expansion joints, sealing and seam roof parapet.
3.外墻板接縫、活動房屋，衛生間的防水密封。
3. wall joint, movable house, waterproof seal of toilet.
4.地下室、人防工程、隧道地鐵、涵洞以及給排水工程的止水密封。
4. watertight seals for basements, civil air defense works, tunnels, subways, culverts and water supply and drainage works.
5.混凝土與橡膠、塑料、陶瓷及各種金屬材料的粘結密封柔性填項項目單位子 控制指標水水中浸泡5個月質量損失%±3Q飽合Ca(OH):溶液浸泡5個月%±310%NaC1溶液5個月%±320oC抗拉強度Mpa≥0.0520oC斷裂伸長率%≥400-30oC抗拉強度Mpa0．7-30oC斷裂伸長率%200密度（20oC）g/ml≥1.45與混凝土（砂漿）面粘接性能 材料斷粘結面完好凍融循環耐久性 凍融循環300次粘結面不破壞流淌值（60o，75o斜角，48h）mm≤1施工度（按照瀝青針入度試驗）0．1mm≥100柔性填料
5. concrete with rubber, plastic, ceramics and various bl materials sealed flexible fill project unit control index of water water for 5 months quality loss% + 3Q saturated Ca (OH): the solution for 5 months and 5 months.% 310%NaC1 solution% + 320oC tensile strength Mpa elongation was more than 0.0520oC% 400-30oC tensile strength Mpa0.7-30oC elongation density%200 (20oC) g/ml = 1.45 and concrete (mortar) surface adhesion material bonding surface intact freeze-thaw durability 300 cycles without damaging the bonding surface flow value (60o, 75o angle, 48h) mm = 1 (according to the construction of asphalt penetration test) 0.1mm = 100 flexible filler
gb填料是干什么用的
(1) GB底膠固化時間較長，一般為24 h，若在12 h內遇水或浸泡，即使表面填料已施工完成，底膠也會發生化學反應而形成薄片狀固狀物，致使底膠失去與混凝土面的粘結力。在該工程施工時，因雨天較多，同時由于面板混凝土養護的需要，無法保證涂刷底膠后表面長時間處于干燥狀態。底膠失效后，需重新打磨、涂刷。SR底膠的粘結性能較好，不易產生脫膠現象，底膠表面覆蓋SR材料后，遇水不會影響粘結效果。
(1) GB adhesive curing time longer, usually 24 h, if water or soaked in 12 h, even if the surface filling has completed the construction, bottom glue chemical reb will occur and the bation of lamellar solids, resulting in the loss and adhesive bonded concrete surface force. In the construction of the project, due to the rainy days, and due to the needs of the maintenance of the concrete slab, it can not guarantee the surface of the rubber after brushing for a long time in a dry state. When the base rubber fails, it needs to be polished and brushed again. The adhesive property of SR base adhesive is good, and it is difficult to produce degumming phenomenon. After covering the SR material on the base surface, the bonding effect will not be affected by water.
大壩周邊縫表面止水施工完成后，檢查發現GB蓋片下部局部有滲水現象，進行了返工處理。
After the completion of the dam surface sealing construction, the inspection found that the lower part of the GB cover piece has the phenomenon of water seepage, and it has been reworked.
(2) GB填料較SR 填料的可塑性及施工性能差。GB填料及蓋片在常溫下施工時必須對板材加壓，但由于現場施工條件的限制，加壓不能確保GB與底膠及混凝土表面的緊密粘結，從而影響防滲效果。而SR 材料的可塑性、延展性較好，易施工，能保證SR填料與底膠及混凝土表面粘結緊密。
(2) the plasticity and construction perbance of GB filler are worse than that of SR filler. GB packing and cover plate must be pressed under the normal temperature, but due to the restrictions of field construction conditions, the pressure can not ensure the tight bond between GB and the bottom rubber and concrete surface, thus affecting the anti-seepage effect. The SR material has good plasticity, good ductility, easy construction, and can ensure the SR filler and the bottom glue and concrete surface bonding closely.
鑒于SR填料較易施工，且與混凝土面的粘結較好，該工程SR及GB蓋片封邊全部采用SR底膠及填料封邊。
gb填料是干什么用的
In view of the easier construction of SR filler and better bonding with the concrete surface, the SR and GB cover sheets of the project all adopt SR bottom adhesive and packing edge banding.
(3) SR底膠涂刷完成后，先進行找平層施工，以改善混凝土與SR 填料的粘結，消除混凝土表面不平整對粘結的影響。而GB填料由于其可塑性較差，無法進行找平層施工，一般是將GB填料和蓋片直接覆蓋在底膠上加壓，這在一定程度上影響了粘結效果。
(3) after the SR primer is finished, the leveling layer is first constructed to improve the bond between concrete and SR filler, and to eliminate the influence of the concrete surface irregularities on the bonding. Because of its poor plasticity, GB filler can not be used for leveling layer construction. Generally, the GB filler and cover sheet are directly covered on the bottom glue to pressurize, which affects the bonding effect to a certain extent.
(4)經檢測SR 和GB 蓋片的強度、延伸率、熱空氣老化等性能，均符合設計和規范要求。GB蓋片厚13 mm左右， SR蓋片厚5～7 cm， GB蓋片的質量較大，坡面施工較困難。
(4) the strength, elongation and hot air aging properties of SR and GB cover sheets are all in line with the requirements of design and specification. The thickness of GB cover is about 13 mm, the thickness of SR cover is 5~7 cm, and the quality of GB cover sheet is larger, and the slope construction is difficult.
(5) GB填料采用疊片包裝，每片厚3 cm左右，片間粘貼雙面防粘紙，施工時防粘紙較容易揭開，同時無需對材料進行大量切割。而SR材料采用大塊包裝，表面粘貼單面防粘紙，受運輸過程的影響， SR材料容易局部變形，造成防粘紙局部扭曲、破損，防粘紙不易揭開，在施工過程中還需進行切割。
(5) GB packing is packed by lamination, each piece is about 3 cm thick, and double anti sticking paper is pasted between the sheets. The anti sticking paper is easy to be uncovered during construction, and it is not necessary to cut a lot of materials. SR bulk materials used in packaging, anti sticking paper stuck to the surface of one side, affected by the transport process, SR material is easy to cause local debation, anti sticking paper local distortion, damage, anti sticking paper is not easy to open, in the construction process also needs to be cut.
二、在施工前應先將底涂液涂于表面，待表面干燥后把縫隙的兩邊10mm處貼上50mm寬的防護膠帶，以防施工中多余的聚硫膠把構筑物表面弄臟。
Two, before the construction, the bottom coating solution should be applied to the surface, after drying the surface, the two sides of the gap 10mm affixed 50mm wide protective tape, in order to prevent the construction of redundant polysulfide glue to the surface of the structure contaminated.
三、 把箱內1桶白色聚硫膠（A組份）與1袋黑色固化劑（B組份）充分?jǐn)嚢杈鶆?，直到無色差為止。
Three, the box of 1 barrels of white polysulfide glue (A component) and 1 bags of black curing agent (B component) fully stirring, until no color difference so far.
gb填料是干什么用的
