鍍層的性質：一般厚度大約2.0-3.0 μm；摩擦系數小于 0.15。（典型為：0.05-0.10間）(against WC/Co ball)；硬度Hp > 1,200kg/mm2 ；深灰黑色；劃痕粘接力：大于60N；相對磨損率：2E-16 m3/Nm (WC-6%Co ball ?5mm, 80 N test ?8mm track, 477rpm, 200mms-1)。
· MoS2基鍍層一般厚度大于1.0 μm；摩擦系數約為0.05 到 0.10之間(against WC/Co ball)；在150kgf的洛氏硬度計壓頭壓入，鍍層不脫落（>HF2），硬度約 950-1050 VHN；深灰色；劃痕粘接力：大于60N；相對磨損率：2E-16 m3/Nm (WC-6%Co ball ?5mm, 40 N test ?8mm track, 477rpm, 200mms-1)。
· ?MoST : Properties of coating
CrN 鍍層
CrN: 鍍層硬度Hf>2000HV，鍍層厚度>3微米；結合力：在150kgf的洛氏硬度計壓頭壓入，鍍層不脫落（>HF2）； 標準劃痕試驗：Lc>60N；鍍層前后的表面粗糙度增加值Ra≤0.01微米，鏡面效果。
CrN coating, the hardness of the coating: Hf>2000Hv, the thickness of the coatings: >3.0um. The adhesion of the coatings: >HF2. And Lc > 60N with Scratch system. The Roughness of the coating Ra<0.01
性能優勢
· Coating deb carried out using a high density of low energy bombarding ions.
使用高密度低能量轟擊離子進行沉積鍍膜。
· Deb of very dense, non-columnar coating structures with low internal stresses.
鍍層致密度好，低柱狀晶結構，內應力低
· Deb of coatings with dense structures at low temperatures.
? 可在低溫環境下沉積致密結構的鍍層
· High efficiency of ion cleaning resulting in coatings with the highest levels of adhesion.
高效率等離子清理以提供高的鍍層結合強度。
· Coatings quality is assured by the use of specially designed Plasmag sputter sources, which create an intense plasma and high ion bombardment of work pieces.
鍍層品質保證是由使用專門設計plasmag濺射源及提供高密度的等離子。
離子濺射二硫化鉬，真空鍍二硫化鉬，PVD二硫化鉬，離子束濺射MoS2，耐高溫：350度，
